Step 2 – Mix it
Reconstitute your peptide like you normally would.
Step 3 – Load the cartridge
Draw up your mixed peptide with a syringe.
- Hold your cartridge and lightly press your thumb on the base.
- (Optional) Vent the cartridge by jabbing a second small needle in off-centre to let air escape.
- Slowly inject your peptide into the centre of the cartridge. Don’t rush it or you’ll blow the stopper out.
Step 4 – Load the pen
- Unscrew your pen and insert the filled cartridge.
- Push it back together. It’s friction fit and latched, so apply a bit of pressure until you see it latched of feel a click.
Step 5 – Prime the pen
- Attach your pen needle.
- Remove both the outer and inner caps.
- Dial up a full dose.
- Hold upright and press the button to push air out.
- Repeat with smaller doses until you see a drop at the tip.
Step 6 – Dose
- Dial to your dose (Numbers are in units).
- Inject wherever you usually go sub-q.
- The plunger will return to zero, and the pen is good to go again next time.
Step 7 – Store
Cap your pen and stick it in the fridge. You’re done.
